next up previous contents
Next: Metering Structure Up: HARDWARE Previous: HARDWARE

Primary Mirror


For the Astro-1 flight, the primary mirror was made of Zerodur, which has a very low thermal expansion coefficient ($\alpha = 0.7 \times 10^{-7}~{\hbox{$^\circ$}}~\rm C^{-1}$). It is a 90 cm f/2 parabola that has been lightweighted by grinding material off the back. A cross section of the mirror is shown in Figure 2-3. The mirror was figured to provide 90$\%$ of the encircled energy within 1$^{\prime \prime}$ and was coated with iridium for high reflectivity in the ultraviolet. It is supported in the primary mirror cell by a clamping structure as shown in Figures 2-2 and 2-3. The mirror clamp is then attached to the mirror cell by three linear actuators (called the focus mechanisms) that can be used to focus and align the HUT optics. The mirror cell, the mirror clamp, and the focus mechanisms are all made of INVAR which also has a low thermal expansion coefficient ($\alpha = 7 \times 10^{-7}~{\hbox{$^\circ$}}~\rm C^{-1}$).

 
Figure 2-3: The HUT primary mirror shown with its clamping structure attached to the mirror cell assembly by the focus mechanism.

For Astro-2, the far-UV throughput of the telescope has been significantly improved by using a Cer-Vit mirror coated with silicon carbide over iridium. The physical characteristics of this mirror (which was the backup mirror for Astro-1) are nearly identical to the original flight mirror, but the SiC coating placed over the iridium improves the far-UV reflectivity by a factor of $\sim2$. Unfortunately, the EUV response below 600 Å is considerably less.

If needed, the HUT primary mirror can be tilted to achieve co-alignment with the WUPPE experiment or for observing offset positions up to $\sim$ 2$^{\prime}$ away. Normally, the WUPPE secondary mirror will be tilted for co-alignment, since the off-axis optical aberrations are less severe for WUPPE than for HUT. To focus or align HUT, the primary mirror along with its clamping structure can be moved, as a whole, fore and aft along the optical axis, or tilted. Each of the focus mechanisms is powered individually by a motor which drives a linear actuator fixed to the primary mirror clamp assembly. A single 400 Hz inverter, located in the EM, drives all the HUT mechanisms and can operate up to three at the same time if they are moving in the same direction (forward or reverse). The linear actuation of the focus mechanisms is accomplished by a differential screw assembly.

Control of the motors is furnished by the DEP, which is located in the EM. Position sensing potentiometers mounted on the gears of the differential screw mechanisms provide the DEP with the position of each mechanism. The software provides for various modes of mirror motion, all of which rely on a calculation of the run-time for each motor to accomplish a given motion. When a commanded motion is completed, the potentiometers are checked to determine if the correct position has been reached. An error message is issued if any one of the mechanisms is off by more than a preset lower limit (4 $\mu$m).

Using a stellar image placed near the center of the HUT TV camera, the crew will focus the telescope by commanding the primary mirror to move fore and aft. The mirror can also be automatically offset, scanned, or rastered during an observation by placing the necessary information in a sequence file. The observation sequence files will be discussed later.


next up previous contents
Next: Metering Structure Up: HARDWARE Previous: HARDWARE

6/23/1999